LR3 (LA) V8-4.4L (2009)
Coolant Reservoir: Service and Repair
The content of this article/image reflects the changes identified in Land Rover TSB LTB00156
Coolant Expansion Tank
Service Repair No - 26.15.01
Removal
1. Remove the LH headlamp assembly.
2. Release the windshield washer reservoir filler neck.
3. Release the coolant expansion tank.
^
Remove the 2 bolts
4. Release the power steering fluid reservoir.
WARNING: Since injury such as scalding could be caused by escaping steam or coolant, do not remove the filler cap from the coolant
expansion tank while the system is hot.
CAUTION: Engine coolant will damage the paint finished surfaces. If spilt, immediately remove the coolant and clean the area with water.
5. Disconnect the 2 hoses from the coolant expansion tank.
^
Position an absorbent cloth to collect fluid spillage.
^
Position a container to collect the fluid.
^
Clamp the hoses
^
Release the 2 clips.
6. Remove the coolant expansion tank.
^
Disconnect the coolant low level sensor electrical connector.
NOTE: Do not disassemble further if the component is removed for access only.
7. Remove the coolant low level sensor.
^
Remove the coolant expansion tank support bracket.