LR3 (LA) V8-4.4L (2009)
11. Install the special tool to the left-hand cylinder head.
12. Install the special tool to the right-hand cylinder head.
13. Remove excess sealant which may squeeze out of front cover sealing surfaces.
14. Install the baffle plate.
^
Tighten to 6 Nm (4 ft. lbs.)
NOTE: Make sure the transit sleeve is correctly positioned and install the new seal over the crankshaft. Do not use any lubricant on the seal, transit
shaft or the crankshaft.
NOTE: Carefully remove the transit sleeve, leaving the seal in place.
15
Using the special tool, position the crankshaft rear oil seal.
CAUTION: Alternate the nut tightening to correctly seat the crankshaft rear oil seal.
16. Using the special tool, install the crankshaft rear oil seal.