LR3 (LA) V8-4.4L (2009)
/v8-4.4l/Page-1541006.png)
30. Remove the heater housing.
31. Disconnect the evaporator core temperature sensor electrical connector.
32. Release the heater core housing.
^
Remove the 2 screws.
^
Remove the 8 clips.
33. Remove the evaporator core.
^
Release the temperature sensor.
Installation
1. Install the evaporator core.
^
Secure the temperature sensor.
2. Secure the heater core housing.
^
Install the clips.
^
Tighten the screws.
3. Connect the temperature sensor electrical connector.
4. Install the heater housing.
5. Passenger side: Install the heater housing to bulkhead Torx bolt and tighten to 6 Nm (4 ft. lbs.).
6. Driver side: Install the heater housing to bulkhead Torx bolt and tighten to 6 Nm (4 ft. lbs.).
7. Install the footwell ducts.
