LR3 (LA) V8-4.4L (2009)
/v8-4.4l/Page-1307012.png)
14. Disconnect the front bumper wiring harness electrical connector.
15. With assistance, remove the BJB and wiring harness.
Installation
All vehicles
1. With assistance, install the BJB and wiring harness.
2. Connect the front bumper wiring harness electrical connector.
3. Attach the hood release cable.
^
Secure with the clips.
4. If installed, connect the pollution sensor electrical connector.
^
Install the grommet.
^
Secure the clip.
5. If installed, connect the speed control module electrical connector.
6. Connect the horn electrical connectors.
7. Connect the hood switch electrical connector.
8. RH side: Secure the wiring harness.
^
Secure the clips.
9. Connect both front impact electrical connectors.
^
Secure the clips.
10. RH side: Attach the air suspension pipe.
11. Connect the ambient air temperature sensor electrical connector.
12. RH side: Attach the engine compartment ground cables.
^
Tighten the nuts to 25 Nm (18 ft. lbs.).
13. RH side: Connect the ABS electrical connector.
14. RH side: Attach the body panel ground cables.
^
Tighten the nut to 25 Nm (18 ft. lbs.).
15. RH side: Connect the body panel electrical connectors.
Vehicles with auxiliary heating
1. RH side: Secure the heater pipes to the body panel.
^
Tighten the nut to 10 Nm (7 ft. lbs.).
All vehicles
1. Driver side: Attach the wiring harness to the bulkhead.
^
Install the grommet.
2. Driver side: Connect the lower A-pillar electrical connectors.
3. Install the air suspension control module.
4. Connect the ABS module electrical connector.
5. Connect the brake fluid reservoir electrical connector.
6. Attach the wiring harness to the plenum.
^
Secure the clips.
^
Tighten the nuts to 4 Nm (3 ft. lbs.).
7. Connect the battery to engine compartment wiring harness electrical connector.
8. Connect the A/C pressure transducer electrical connector.
