LR3 (LA) V8-4.4L (2009)
Impact Sensor: Service and Repair
C-Pillar Side Impact Sensor
C-Pillar Side Impact Sensor
Removal
WARNING:
^
It is imperative that before any work is undertaken on the SRS system, the appropriate information is read thoroughly.
^
Always disconnect both battery cables before beginning work on the SRS system. Disconnect the ground cable first. Never reverse
connect the battery.
NOTE: If the SRS component is to be replaced, the bar code of the new unit must be recorded.
1. Make the SRS system safe.
2. Remove the C-pillar lower trim panel.
3. Remove the side impact sensor.
^
Remove the 2 Torx bolts.
^
Disconnect the electrical connector.
Installation
1. Install the side impact sensor.
^
Tighten the Torx bolts to 8 Nm (6 ft. lbs.).
^
Connect the electrical connector.
2. Install the C-pillar lower trim panel.