LR3 (LA) V8-4.4L (2009)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor
Service Repair No - 18.30.24
Removal
1. Disconnect the battery ground cable.
2. Remove the engine cover.
NOTE: Removal of the RH is similar to this procedure.
3. Remove the CMP sensor.
^
Disconnect the electrical connector.
^
Remove the Torx screw.
^
Discard the O-ring seal.
Installation
1. To install, reverse the removal procedure.
^
Clean the component mating faces.
^
Install a new O-ring seal.
^
Tighten the Torx screw to 7 Nm (5 ft. lbs.).