LR3 (LA) V8-4.4L (2009)
Ride Height Sensor: Service and Repair
Suspension Height Sensor
Service Repair No - 60.36.01
Removal
1. NOTE: The right hand sensor has a black colored lever and the left hand sensor has a white colored lever.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the wheel and tire.
3. CAUTION: Do not use excessive force to disconnect the height sensor link.
Remove the suspension height sensor.
^
Disconnect the height sensor link arm.
^
Disconnect the electrical connector.
^
Remove the 2 Torx screws.
Installation
1. To install, reverse the removal procedure.
^
Tighten the screws to 2.2 Nm (1.5 ft. lbs.).
2. CAUTION: Height suspension calibration, using T4, must always be carried out if the suspension height sensor fixings are removed.
Use T4 to re-calibrate the suspension system.