LR3 (LA) V8-4.4L (2009)
Drive/Propeller Shaft: Service and Repair
Front Driveshaft
Front Driveshaft - 4.4L
Service Repair No - 47.15.02
Removal
1. CAUTION: It is possible to fit the driveshaft incorrectly. Note the orientation before removal.
Disconnect the battery ground cable.
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
3. Remove the exhaust system.
4. CAUTION: Mark the position of the driveshaft flange in relation to the drive pinion flange.
CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
Release the driveshaft from the transfer case drive flange.
^
Remove the 6 Torx bolts and washers, discard the bolts.
5. CAUTION: Mark the position of the driveshaft flange in relation to the drive pinion flange.
CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
Release the driveshaft from the front axle drive flange.
^
Remove the 6 Torx bolts and washers, discard the bolts.