LR3 (LA) V8-4.4L (2009)
/v8-4.4l/Page-1054002.png)
6. Remove the front driveshaft.
^
Compress the joints to disengage the drive flanges.
Installation
1. Install the driveshaft.
^
Clean the components.
^
Compress the joints to engage the drive flanges.
2. Attach the driveshaft to the front axle drive flange.
^
Tighten the new Torx bolts to 45 Nm (33 ft. lbs.), then a further 90 degrees.
3. Attach the driveshaft to the transfer case drive flange.
^
Tighten the new Torx bolts to 45 Nm (33 ft. lbs.), then a further 90 degrees.
4. Install the exhaust system.
5. Connect the battery ground cable.
