LR3 (LA) V8-4.4L (2009)
Seals and Gaskets: Service and Repair
Transfer Case Rear Output Shaft Seal
Transfer Case Rear Output Shaft Seal
Special Service Tools
Removal
1. NOTE: This process only applies to vehicles up to and including VIN305488.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the fuel tank heat shield.
^
Remove the 3 bolts and 2 nuts.
3. CAUTION: Mark the position of the driveshaft flange in relation to the drive pinion flange.
CAUTION: To avoid damage to the joint or gaiter, do not allow the driveshaft to hang.
Release the driveshaft from the transfer case drive flange.
^
Remove the 6 Torx bolts and washers.