LR3 (LA) V8-4.4L (2009)
Headlamp Washer Pump: Service and Repair
Headlamp Washer Pump
Removal
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Remove the LH fender splash shield.
3. Release the headlamp washer pump hose.
^
Drain the washer reservoir fluid.
4. Disconnect the headlamp washer pump electrical connector.
5. Remove the headlamp washer pump.
^
Discard the O-ring seal.
Installation
1. Install the headlamp washer pump.
^
Install a new O-ring seal.
2. Connect the headlamp washer pump electrical connector.
3. Connect the headlamp washer pump hose.
4. Install the fender splash shield.
5. Lower the vehicle.
6. Top-up the windshield washer reservoir.