LR3 (LA) V8-4.4L (2009)
/v8-4.4l/Page-2255001.png)
Wiper Motor: Service and Repair
Windshield Wiper Motor
Windshield Wiper Motor
Removal
1. Remove the plenum chamber panel.
2. Remove the windshield wiper motor and linkage.
^
Remove the 2 bolts.
^
Remove the 2 clips.
^
Disconnect the electrical connector.
NOTE: Do not disassemble further if the component is removed for access only.
3. Noting the fitted position, remove the wiper linkage.
^
Remove the 2 bolts.
^
Remove the nut.
Installation
1. Install the wiper linkage.
^
Tighten the bolts to 10 Nm (7 ft. lbs.).
^
Tighten the nut to 25 Nm (18 ft. lbs.).
CAUTION: Make sure the windshield wiper motor is located on its stud prior to installing the bolts.
2. the windshield wiper motor and linkage.
^
Tighten the bolts to 6 Nm (4 ft. lbs.).
^
Connect the electrical connector.
^
Install the clips.
3. Install the plenum chamber panel.
