LR3 (LA) V8-4394cc 4.4L (2005)
/v8-4394cc_4.4l/Page-2479006.png)
13.
Cut the original wire (wiring color green/yellow), allowing enough free wire to allow splicing operation. (Figure 9)
14.
Position the heat shrink sleeve onto the wire.
CAUTION:
The electrical connector must be securely crimped and connected.
15.
Install and crimp the connections.
CAUTION:
Care must be taken when using a heat gun to avoid damage to the surrounding area.
16.
Position the heat shrink wrap to the crimped connector and apply heat until the wrap is secure. (Figure 10)
17.
Insert the new repaired wire inside the wiring conduit.
18.
Using electrical tape, seal the conduit and new electrical connection.
CAUTION:
The Anti-backout cannot be installed unless the terminals are correctly installed. Force is NOT required.
19.
Install the two new terminals into the park brake electrical connector as follows:
^
Align the two terminals so the rounded portion of the neck, faces towards the retracted anti-back-out device.
^
Insert the terminals and ensure they are correctly located.
^
Secure the electrical terminals with the anti-backout device.
20.
Install the electrical connector.
