LR3 (LA) V8-4394cc 4.4L (2005)
Front Fender Liner: Service and Repair
Fender Splash Shield
Service Repair No - 76.10.48
Removal
1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.
2. Remove the fender moulding.
3. Remove the fender splash shield.
^
Remove the 2 screws.
^
Remove the 6 retainers.
^
Disconnect the electrical connector.
4. NOTE: Do not disassemble further if the component is removed for access only.
Remove the tire pressure antenna.
^
Remove the 2 retainers.
Installation
1. Install the tire pressure antenna.
^
Install the retainers.
2. Install the fender splash shield.
^
Connect the electrical connector.
^
Install the retainers.
^
Install the screws.
3. Install the fender moulding.