LR3 (LA) V8-4394cc 4.4L (2005)
Accelerator Pedal: Service and Repair
Accelerator Pedal
Removal
1. Remove the driver side closing trim panel.
^
Release the clip.
^
Remove the 2 screws.
^
Disconnect the electrical connector.
2. Remove the accelerator pedal assembly.
^
Release the wiring harness.
^
Remove the 3 nuts.
^
Disconnect the electrical connector.
NOTE: Do not disassemble further if the component is removed for access only.
3. Remove the accelerator pedal bracket.
^
Remove the 3 nuts and bolts.
Installation
1. Attach the accelerator pedal bracket.
^
Tighten the nuts and bolts to 10 Nm (7 ft. lbs.).
NOTE: Make sure the electrical connector is securely connected.
2. Install the accelerator pedal assembly.