LR3 (LA) V8-4394cc 4.4L (2005)
2.
Determine the current software levels of the transfer case control module as follows:
^
Enter vehicle details.
^
Select the "Vehicle Configuration" tab.
^
Select "Module Information."
^
Select "Network Integrity Test."
Note the software part numbers displayed on the WDS screen.
3.
Configure the transfer case control module software as follows:
^
Return to "Vehicle Configuration" screen.
^
Select "Module Configuration".
^
If the software part number displayed on the screen is not the same as noted in Step 2 proceed to configure the transfer case control module as
follows:
^
Select "Configure Existing Modules".
^
Select "Transfer Case Control Module" from the sub-menu.
^
Check tick-box to continue and follow on-screen instructions.
4.
Repeat Step 2 to confirm the software level change.re level change.
5.
Exit the WDS session and disconnect the diagnostic equipment from the vehicle.
Disclaimer