LR3 (LA) V8-4394cc 4.4L (2005)
^
Remove and discard the sensor link pin from the upper arm. (Figure 5)
^
Install the new sensor link pin to the upper arm. Tighten bolts to 9Nm (6.6lbf ft).
CALIBRATE SUSPENSION SYSTEM RIDE HEIGHT
CAUTION:
Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the
vehicle.
CAUTION:
A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module
programming.
1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.
2. Turn ignition ON (engine not running).
3. Verify air suspension system compressor is not running.
^
If the compressor is running, use the Integrated Diagnostic System (IDS) for Diagnostic Trouble Codes (DTC) and rectify as necessary.
^
If the compressor is not running, continue to step 4.
NOTE:
IDS must be loaded with IDS-DVD120_V6.08 or later and Calibration File 29 or later.
4. Connect the IDS to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.
5. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.
6. From the Session Type selection screen, choose Service Functions~.
7. Select the Selected Symptoms tab, and then select:
^
Chassis
8. Select 'continue'.