LR3 (LA) V8-4394cc 4.4L (2005)
5. Remove the valve body.
^
Position a container to collect spillage.
^
Remove the 10 Torx screws.
6. Using the special tool, remove the 4 seals.
7. Remove the seal block.
Installation
1. CAUTION: Make sure that when fully fitted, all seals protrude by the same amount.
CAUTION: Engage the selector lever with the groove in the piston rod.
Install the valve body.
^
Clean the component mating faces.
^
Install new seals.
^
Install a new seal block.
^
Tighten the Torx screws to 8 Nm (6 ft. lbs.).
2. Install a new electrical connector sleeve.
^
Secure with retainer.
3. Connect the electrical connector.