landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

A/T - Gear Selector Lever Difficult to Operate/DTC P0850|Page 5534 > < Transmission Position Switch/Sensor, A/T|Locations|Page 5525
Page 1
background image

Shifter A/T: All Technical Service Bulletins
A/T - Gear Selector Lever Difficult to Operate/DTC P0850

No: LA307-001
Issue: 1
Date: 12 Sep 2006

SECTION: 307-05 - AUTOMATIC TRANSMISSION SYSTEM

Gear Selection Difficult or Selection Lever Stiff to Operate

AFFECTED VEHICLE RANGE:
LR3 (LA)

VIN: 5A000360 to 6A390787

CONDITION SUMMARY:

GEAR SELECTION MAY BE DIFFICULT OR SELECTION LEVER MAY BE STIFF TO OPERATE

Situation:
A customer may report a concern that the automatic transmission selector lever has become very stiff to operate, or that it has become difficult to select
forward or reverse gears. Diagnostic Trouble Code (DTC) P0850 - "Park/Neutral switch" may be stored in the transmission control module.

Excessive friction and binding of the selector cable pivot bushing within the gear selector lever may be the cause. Over-tightening of the gear selector
cable adjuster clamp can result in a dimensional tolerance issue that may lead to excessive friction and binding of the pivot bushing.

Action:
Should a customer express this concern, refer to the Repair Procedure detailed in this bulletin to replace the selector lever.

PARTS:

NOTE:

Parts held by Caterpillar UK have been validated to be within dimensional tolerance specification.

UCD500030

Gear selector lever

Qty 1

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always
refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers.

Labor only claims must show the causal part number with a quantity of zero.

Normal warranty policy and procedures apply.

REPAIR PROCEDURE

REPLACE GEAR SELECTOR LEVER

CAUTION

The selector cable adjuster clamp nut must be tightened between 10 to 12Nm (7.5 to 8.5 lbf-ft). The specified torque must not be exceeded.

NOTE:

Global Technical Reference (GTR) lookup sequence is as follows:

GTR Home > NAS > Service Information/ LA - LR312005 > Workshop Manuals> Bookmark Powertrain/Automatic

A/T - Gear Selector Lever Difficult to Operate/DTC P0850|Page 5534 > < Transmission Position Switch/Sensor, A/T|Locations|Page 5525