Refit Clutch Housing in Type B Gearbox - R380 Manual Gearbox Overhaul
MANUAL GEARBOX
48
OVERHAUL
Clutch housing - Type A gearbox - Refit
1. Position clutch housing to gearbox.
2. Fit securing bolts.
NOTE: The 12 x 45 mm bolts must be fitted
through locating dowels.
3. Tighten bolts by diagonal selection to 72 Nm
(53 lbf.ft).
4. Fit pivot post, fit and tighten bolts.
5. Apply lithium based grease to pivot post, pads
and push rod.
6. Position pads to clutch release lever, fit release
bearing.
7. Fit new clips to retain pads.
NOTE: Clips may become displaced in
service with no loss of performance.
8. Fit release lever.
9. Apply lithium based grease to splines of input
shaft.
Clutch housing - Type B gearbox - Refit
1. Position clutch housing to gearbox.
2. Fit securing bolts.
NOTE: The 12 x 45 mm bolts must be fitted
through locating dowels.
3. Tighten bolts by diagonal selection to 72 Nm
(53 lbf.ft).
4. Apply lithium based grease to pivot post,
release lever, socket and push rod.
5. Fit a new ’C’ clip to pivot post, fit post.
6. Fit spring clip to release lever, fit but do not
tighten bolt.
