Refit Clutch Housing for Type C Gearbox with R380 Manual Gearbox
MANUAL GEARBOX
OVERHAUL
49
7. Position release lever to pivot post ensuring
spring clip is located behind ’C’ clip; tighten
bolt.
8. Fit clutch release bearing and retain using new
clips.
NOTE: Clips may become displaced in
service with no loss of performance.
9. Apply lithium based grease to splines of input
shaft.
Clutch housing - Type C gearbox - Refit
1. Position clutch housing to gearbox.
2. Fit securing bolts.
NOTE: The 2 longest bolts must be fitted
at locating dowel positions.
3. Tighten bolts by diagonal selection to 72 Nm
(53 lbf.ft).
4. Apply lithium based grease to pivot post.
5. Fit release lever and clutch release bearing.
6. Apply lithium based grease to splines of input
shaft.
