R380 Manual Gearbox Overhaul
MANUAL GEARBOX
OVERHAUL
41
Selector quadrant - Type A gearbox - Refit
1. Position selector quadrant to selector shaft.
2. Apply Loctite 290 to threads of a new setscrew.
Fit and tighten screw to 25 Nm (18 lbf.ft).
CAUTION: Ensure end of setscrew locates
in hole in selector shaft.
3. Move selector shaft to neutral position.
Gear change lever yoke - Type B gearbox - Refit
1. Position gear change lever yoke on selector
shaft with ball facing towards output shaft.
2. Apply Loctite 290 to threads of a new setscrew,
fit and tighten screw to 25 Nm (18 lbf.ft).
CAUTION: Ensure end of setscrew locates
in hole in selector shaft.
