R380 Manual Gearbox Overhaul
MANUAL GEARBOX
42
OVERHAUL
Gear change lever yoke - Type D gearbox - Refit
1. Position gear lever yoke on selector shaft with
ball facing towards output shaft.
2. Apply Loctite 290 to threads of a new setscrew.
Fit and tighten screw to 25 Nm (18 lbf.ft).
CAUTION: Ensure end of setscrew locates
in hole in selector shaft.
Remote housing - Type A gearbox - Refit
1. Apply sealant, Part No. STC 3254 to mating
surfaces and fit to extension housing.
2. Position remote housing to extension housing
and gearcase ensuring rollers locate in
quadrant.
3. Fit and lightly tighten 3 bolts in positions
shown.
NOTE: Bolts are tightened when gear
change housing is fitted.