Range Rover (LH) V8-3.5L (1987)
Use care in order to avoid damaging the seal installation area of the transfer gearbox.
2.
Lubricate seal lip with transmission fluid and install seal using tool LRT-41-013.
CAUTION:
A new style flange must be installed on the front output shaft when replacing the seal.
3.*
Install new mudshield and flange.
4.
Replace rubber-sealing washer with transfer box output flange spline seal RTC6363.
5.
Fit washer and Nyloc nut finger tight.*
6.
Tighten nut to 220 Nm. (162 lbf.ft).
7.
Reinstall remaining components as described in WSM section 41.
8.
Top off transfer gearbox with Dexron III ATF.