Range Rover (LH) V8-3.9L (1989)
/v8-3.9l/Page-388002.png)
29. Clean threads of cover fixing bolts, apply Loctite 372 to threads.
30. Fit timing cover, fit fixing bolts. Tighten to 28 Nm.
31. Fit generator support strut to front cover.
32. Tighten sump to timing cover fixings to 10 Nm.
33. Tighten sump fixings to 10 Nm.
34. Lubricate distributor O ring.
35. Fit distributor in position marked.
36. Align oil pump drive, if distributor does not sear correctly.
37. Fit distributor clamp. Tighten to 20 Nm.
38. Locate generator tensioner on water pump bracket.
39. Connect heater hose, tighten clip.
40. Connect oil pressure switch.
41. Connect botton hosse, tighten clip.
42. Connect vacuum pipe to distributor.
43. Loosen power steering pump pivot, lower pump.
44. Connect distributor feed wire.
45. Connect wire ties to generator tensioner.
46. Fit power steering pump bracket to water pump. Tighten to 28 Nm.
47. Fit power steering pump bracket.
48. Position distributor cap. Fit plug leads to plugs and clips.
49. Clip distributor cap in position.
50. Fit water pump pulley.
51. Fit crankshaft pulley.
52. Tension drive belts correctly.
53. Check ignition timing.
54. Refill cooling system.
