Range Rover (LH) V8-3.9L (1989)
/v8-3.9l/Page-1248001.png)
Instrument Panel Bulb: Service and Repair
NOTE:
-
If difficulty is experienced in changing bulbs due to the limited space available the instrument panel fasteners should be removed to enable the
panel to be raised above the dash as far as other connections permit.
-
The "No Charge/Ignition On" warning light, identified by its red colored bulb holder, is of a higher wattage and is the only bulb which can be
pulled from its holder and replaced independently.
REMOVE
-
Disconnect the battery negative terminal.
-
Unclip the back of the cowl from the instrument panel to give access to the panel and warning light bulbs in the back of the instrument case.
-
Remove the appropriate bulb holder unit by rotating it counter-clockwise and withdrawing it.
-
Fit a new bulb holder unit and rotate clockwise to lock in position. The correct bulb type is a 1.2 watt bulb/holder unit, except the ignition bulb
which is 2 watt wedge base type.
-
Refit the cowl and reconnect the battery.
