Range Rover (LH) V8-3.9L (1989)
Radius Arm Bushing: Service and Repair
Rear
Upper
CAUTION: When pressing in the new bushings ensure that pressure is applied to the outer edge of the bushing only and not to the rubber inner.
REPLACE
-
Using a suitable hydraulic or bench press and a piece of metal tubing slightly smaller than the outside diameter of the bushing, press out the rubber
mounted bushings. Ensure the steel tubing locates on the outer edge of the bushing and not on the rubber inner.
-
Fit the replacement bushing assembly centrally in the housing.
Lower
CAUTION: When pressing in the new bushings ensure that pressure is applied to the outer edge of the bushing only and not to the rubber inner.
Replacing the Bush
-
Using a suitable hydraulic or bench press and a piece of metal tubing slightly smaller than the outside diameter of the bushing, press out the rubber
mounted bushings. Ensure the steel tubing locates on the outer edge of the bushing and not on the rubber inner.
-
Fit the replacement bushing assembly centrally in the housing.