Range Rover (LM) V8-4.2L SC (2006)
^
Tighten the Torx bolts to 10 Nm (7 ft. lbs.).
^
Connect the electrical connectors.
2. Install the cubby box liner.
3. Install the floor console rear panel.
^
Secure with the clips.
^
If installed, connect the electrical connectors to the AVIO module.
4. Attach the ignition switch to the floor console.
^
Tighten the Torx screws.
5. Install the floor console upper panel.
6. Install the floor console side panels.
^
Remove the 2 Torx screws.
^
Release the 4 clips.
Floor Console Upper Panel
Floor Console Upper Panel
Service Repair No - 76.25.11
Removal
1. Position the transmission selector lever into NEUTRAL.
^
Turn the ignition key to position II.
^
Press the brake pedal.
2. WARNING: The selector lever knob will be released suddenly, keep face clear during removal.
Remove the transmission selector panel.
^
Release the 8 clips.
^
Pull the selector lever knob upwards.
^
Disconnect the 4 electrical connectors.
3. Remove the ashtray.
^
Remove the ashtray insert.
^
Release the 4 clips.