Range Rover (LM) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-1499001.png)
Brake Rotor/Disc: Service and Repair
Front Brakes
Brake Disc - Vehicles With: Standard Brakes
Brake Disc - Vehicles With: Standard Brakes
Service Repair No - 70.12.10
Removal
CAUTION: Brake discs must be renewed in pairs.
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
1. Raise and support the vehicle.
2. Remove the wheel and tire.
CAUTION: Do not allow the brake caliper to hang on the brake hose.
CAUTION: LH side: Do not allow the brake caliper to hang on the brake pad wear warning sensor lead.
3. Release the brake caliper.
^
Remove and discard the 2 bolts.
^
Tie the brake caliper aside.
4. Remove the brake disc.
^
Remove the Allen screw.
Installation
1. Make sure the brake disc and hub mating surfaces are clean.
2. Install the brake disc.
^
Tighten the Allen screw to 16 Nm (12 ft. lbs).
3. Install the brake caliper.
^
Clean the component mating faces.
^
Tighten the new bolts to 65 Nm (48 ft. lbs), then a further 90 degrees.
4. Install the wheel and tire.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs).
5. Depress the brake pedal several times, check the fluid level in the brake fluid reservoir and top-up with brake fluid if necessary.
