Range Rover (LM) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-732002.png)
8. Remove the LH front sidemember exhaust heat shield.
^
Remove the 4 nuts.
9. Remove the exhaust manifold.
^
Remove and discard the 8 bolts.
^
Remove the gasket/heat shield retaining bolt.
^
Discard the gasket/heat shield.
Installation
All vehicles
1. Install the exhaust manifold.
^
Clean the component mating faces.
^
Install the gasket/heat shield and tighten the bolt to 10 Nm (7 ft. lbs).
^
Install, and lightly tighten the bolts.
^
Evenly and progressively, tighten the bolts in the sequence shown to 20 Nm (15 ft. lbs).
2. Install the LH front sidemember exhaust heat shield.
^
Tighten the nuts.
Left-hand drive vehicles
3. Attach the lower steering column.
^
Make sure that the steering gear tag is aligned correctly, as shown.
^
Install a new Torx(R) bolt and tighten to 24 Nm (18 ft. lbs).
