Range Rover (LM) V8-4.2L SC (2006)
Power Steering Fluid: Customer Interest
Steering - Squeak From Steering Gear
No.: LTB00112
Issue: 1
Date: 16 April 2008
THIS BULLETIN REPLACES 57/01/05NAS DATED 26 JUNE 2006. THE CHANGES ARE NOT HIGHLIGHTED.
SECTION: 211
Squeak from Steering Column / Steering Gear Pinion Seal Squeak - Repair Procedure
AFFECTED VEHICLE RANGE
CONDITION SUMMARY:
Situation:
A customer may complain of a 'squeak' noise from the steering column area when turning the steering wheel. This condition may be caused by a lack of
lubrication of the power steering pinion seal.
NOTE:
A similar squeak can be traced to the steering column bushing and grommet. Refer to TIB 57/02/03NAS for information on the lubrication of the
grommet to eliminate this noise source.
Action:
In the event of a customer concern of the above, follow the Repair Procedure outlined below to add the specified power assist steering (PAS) fluid and
additive to the PAS system.
PARTS
WARRANTY
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always
refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
REPAIR PROCEDURE
DRAIN PAS SYSTEM
1.
Remove PAS fluid reservoir cap.
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
NOTE: