Range Rover (LM) V8-4.2L SC (2006)
Camshaft Position Sensor: Service and Repair
Camshaft Position (CMP) Sensor LH
Camshaft Position (CMP) Sensor LH
Service Repair No - 18.30.25
Removal
1. Disconnect the battery ground cable.
2. Remove the engine cover.
3. Remove the camshaft position (CMP) sensor.
^
Disconnect the electrical connector.
^
Remove the bolt.
^
Discard the O-ring seal.
Installation
1. Install the CMP sensor.
^
Clean the component mating faces.
^
Install a new O-ring seal.
^
Tighten the bolt to 7 Nm (5 ft. lbs.)
^
Connect the electrical connector.
2. Install the engine cover.
3. Connect the battery ground cable.