Range Rover (LM) V8-4.2L SC (2006)
Accelerator Pedal: Service and Repair
Accelerator Pedal
Service Repair No - 19.20.01
Removal
1. Remove the driver side closing trim panel.
^
Release the clip.
^
Remove the 2 screws.
^
Disconnect the electrical connector.
2. Remove the accelerator pedal assembly.
^
Release the wiring harness.
^
Remove the 3 nuts.
^
Disconnect the electrical connector.
3. Remove the accelerator pedal bracket.
^
Remove the 3 nuts and bolts.
NOTE: Do not disassemble further if the component is removed for access only.
Installation
1. Attach the accelerator pedal bracket.
^
Tighten the nuts and bolts to 10 Nm (7 ft. lbs.).
2. Install the accelerator pedal assembly.
^
Connect the electrical connector.