landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Engine Controls - MIL ON/DTC's P0442/P0455|Page 4209 > < Engine Controls - Low Performance/DTC P061A-29|Page 4204
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - MIL ON/DTC's P0442/P0455

No.: LM-303-0020

Issue: 1

DATE: May 05, 2006

SECTION: 303-08

Evaporative Loss System DTC P0442 P0455

AFFECTED VEHICLE RANGE:
Range Rover (LM)

VIN: 6A194480 to 6A227771

CONDITION SUMMARY:

MIL ILLUMINATION

Situation: 

A customer may report a concern that the Check Engine lamp has illuminated. Investigation using the Worldwide Diagnostic System (WDS) reveals
diagnostic trouble codes (DTCs) P0455 (evaporative loss gross leak detected) or P0442 (evaporative loss small leak detected). The most likely cause of
the above lamp display is an incorrectly installed or missing fuel filler cap. 

Action: 

Should a customer express concern regarding the above, refer to the Service Procedure detailed in this bulletin to update the engine control module
software to the latest configuration.

On vehicles built after 6A227771 and on updated vehicles a message 'Fuel Tank Cap Loose or Missing' will display at the first loose cap event
prompting the owner to check the gas cap. When the cap is properly installed shortly after the message is displayed the engine warning lamp will not
illuminate because the on-board diagnostics require two consecutive occurrences to illuminate the lamp. If the customer has not taken the opportunity to
install the filler cap correctly a second sequential event will prompt the Check Engine lamp illumination with the corresponding trouble codes.

TOOLS:
WDS CD13 with Patch File 2 or later

WARRANTY

REPAIR PROCEDURE

DOWN LOAD LATEST GENERATION SOFTWARE

NOTE:

The on-board diagnostics require two consecutive occurrences of a detected evaporative loss system leak to illuminate the lamp (the first
detection being stored in memory).

^

When illuminated, a service visit is required to use T4/WDS to rectify the leak and extinguish the lamp.

^

In most cases, the leak is traced to an incorrectly installed filler cap.

Engine Controls - MIL ON/DTC's P0442/P0455|Page 4209 > < Engine Controls - Low Performance/DTC P061A-29|Page 4204