Range Rover (LM) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-1740003.png)
16. Measure and mark the four points of the 'X' onto the under-hood liner, as dimensioned in Attachment 1 and 2 as follows: (Illustrated in Figure 3)
*
31 mm = 1.22 in
^
55 mm = 2.15 in
^
80 mm = 3.15 in
^
117 mm = 4.61 in
^
138 mm = 5.43 in
^
186 mm = 7.32 in
^
195 mm = 7.67 in
17. Release the liner from the hood for access.
18. Cut through the hood liner diagonally across the square, notching out the lower triangle piece as illustrated in Figure 3.
19. Discard the lower triangle piece.
20. Keeping the outer liner material intact, carefully separate and remove the backing foam from the liner in the areas behind the three remaining
triangles only.
21. Fold the liner material of three triangles back and under the liner, leaving a neat and straight edge.
CAUTION: When using aerosol spray adhesive, care must be taken to protect the surrounding work area from over-spray.
NOTE: Sufficient time is needed for the contact adhesive to cure. Closing the hood will allow the liner to hold the correct position until the
adhesive has hardened. The hood should remain closed for a minimum of 24 hours.
22. Using a suitable contact adhesive (e.g. STC50550), secure the folded back triangles to the hood and to the rearmost edges of the liner.
23. Once the adhesive has hardened, properly secure the under-hood liner and gas struts.
24. Ensure the tires are set to the correct inflation pressures before returning the vehicle.
