Range Rover (LM) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-1806003.png)
10. Remove pins LRT-60-033/3.
11. Remove bearing track from drive flange using a bearing separator.
Refit
1. Clean hub and drive flange.
2. Position anvil, LRT-60-033/10 to bed of hydraulic press and locate hub on anvil.
3. Ensure hub and bearing mating surfaces are clean and dry.
4. Apply stud/bearing fit, STC 50553 to bearing mating surface in hub for half its length.
