Range Rover (LM) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-1347002.png)
^
Using a transmission jack, support the axle.
^
Remove and discard the nut and bolt.
^
Remove the 2 bolts.
8. CAUTION: Note the fitted position of the bush and mark the sub-frame to aid assembly.
NOTE: Move the axle case rearwards for access.
Using the special tools, remove the rear axle housing front bushing.
Installation
1. CAUTION: Lubricate the new bush with rubber lubricant to aid assembly.
CAUTION: Align the new bush to the mark on the sub-frame.
Using the special tools, install the rear axle housing front bushing.
^
Clean the component mating faces.
2. Install the axle assembly.
^
Clean the component mating faces.
^
Tighten the bolts to 100 Nm ( 74 lb. ft).
^
Tighten the new nut and bolt to 120 Nm (89 lb. ft), then a further 180 degrees.
3. Connect the axle case breather line.
4. Attach the driveshaft to the rear axle drive flange.
^
Clean the component mating faces.
^
Install the washers.
^
Tighten the Torx bolts to 44 Nm (32 lb. ft), then a further 45 degrees.
5. Install the fuel tank heat shield.
^
Tighten the screws.
6. Install the exhaust system.
7. Install the wheels and tires.
^
Tighten the wheel nuts to 140 Nm (103 lb. ft).
8. Connect the battery ground cable.
