Range Rover (LM) V8-4.2L SC (2006)
8. CAUTION: Make sure the ball joint seal is not damaged. A damaged seal will lead to the premature failure of the joint.
Using the special tool release the RH rear lower arm.
^
Loosen the nut.
^
Remove the nut.
9. Loosen the RH tie rod end locking nut.
10. CAUTION: Make sure the ball joint seal is not damaged. A damaged seal will lead to the premature failure of the joint.
Using the special tool release the RH tie rod end.
^
Remove and discard the nut.
11. Position a container to collect the fluid spillage.
12. Install the special tool, to the inner halfshaft joint.
13. Release the clip.
14. RH front: With assistance, remove the halfshaft and wheel knuckle assembly.
^
Remove the 2 nuts and 2 bolts.