Range Rover (LM) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-1360008.png)
15. Remove and discard the clip from the RH halfshaft.
16. RH front: Remove and discard the halfshaft seal.
Installation
1. Using the special tool, install a new halfshaft seal.
^
Lubricate the seal with clean differential fluid.
2. RH front: With assistance, install the wheel knuckle.
^
Install a new circlip.
3. Secure the wheel knuckle assembly to the shock absorber and spring assembly.
^
Tighten the nuts and bolts to 250 Nm (184 ft. lbs.).
4. Secure the RH tie rod end.
^
Install a new nut and tighten to 80 Nm (59 ft. lbs.).
5. CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
Secure the RH rear lower arm.
^
Tighten the nut to 80 Nm (59 ft. lbs.).
^
Tighten the tie rod bolt to 165 Nm (122 ft. lbs.) plus a further 90 degrees.
6. CAUTION: Only tighten the nuts and bolts when the suspension is in the normal drive position.
Secure the RH front lower arm.
^
Tighten the nut to 80 Nm (59 ft. lbs.).
^
Tighten the lower arm bolt to 165 Nm (122 ft. lbs.) plus a further 90 degrees.
7. RH side front: Secure the suspension height sensor.
8. Secure the stabilizer bar links.
^
Tighten the nuts to 100 Nm (74 ft. lbs.).
9. Secure the RH front ABS sensor and wiring harness.
^
Apply anti-seize compound to the ABS sensor.
^
Tighten the bolt to 8 Nm (6 ft. lbs.)
^
Secure the clip.
10. Install the RH front brake disc.
11. Install the front wheels and tires.
^
Tighten the wheel nuts to 140 Nm (103 ft. lbs.).
12. Check and top-up the differential case.
^
Remove the container.
