Range Rover (LM) V8-4.2L SC (2006)
/v8-4.2l_sc/Page-1371003.png)
CAUTION: Ensure ball joint seal is not damaged. A damaged seal will lead to premature failure of the joint.
15. Remove and discard nut securing track rod ball joint to steering arm.
16. Fit an M14 nut to ball pin, flush with end of pin.
17. Using LRT-57-036 separate ball pin from steering arm. Remove M14 nut and release ball pin from steering arm.
CAUTION: Ensure ball joint seal is not damaged. A damaged seal will lead to premature failure of the joint.
18. Fit center screw LRT-60-030/3 to LRT-60-030/1 and fit to hub with spacer LRT-60-030/2. Secure with nuts LRT-60030/5.
19. Tighten center screw to press drive shaft from flange.
20. Remove tools.
21. Remove 2 nuts and bolts securing hub to damper.
22. Remove hub assembly.
Refit
1. Clean hub to damper mating faces
2. Clean drive shaft and flange splines.
3. Lightly lubricate splines.
4. Position hub assembly and fit upper bolt, locate drive shaft to hub, align hub and fit lower bolt Tighten bolts securing hub to damper to 250 Nm
(184 ft. lbs.).
5. Fit LRT-60-030/4 to drive shaft.
