Range Rover (LM) V8-4.4L (2009)
REPAIR PROCEDURE
UPDATE SUSPENSION SYSTEM CONTROL MODULE SOFTWARE
CAUTION:
Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the vehicle.
CAUTION:
A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during diagnosis / module programming.
1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.
NOTE:
IDS must be loaded with IDS-DVD119_V8 or later and Calibration File 21 or later.
2. Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.
3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.
4. From the Session screen, select the 'Diagnosis tab'.
5. Select the 'Selected Symptoms tab', and then select:
^
Chassis > Suspension system > Vehicle dynamic suspension
6. Select 'continue'.
7. Select the 'Recommendations tab'.
8. Configure the 'Ride level control module'.
^
Follow all on-screen instructions to complete this task.
9. Exit the current session.
10. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.
Disclaimer