landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

All Other Service Bulletins for Navigation Module: > < Campaign - Navigation System Software Update|Page 7073
Page 3
background image

14.

Wait approximately 60 seconds without closing any doors and observe that the red power LED on the NAV computer is extinguished.

15.

Switch on the ignition, and verify that the Satellite Navigation system powers up correctly displaying the Land Rover logo.

16.

Switch off the ignition.

17.

Install the trim panel in the left hand side of the luggage compartment.

INSTALL CAMPAIGN LABEL

NOTE:

Campaign labels may have multiple Campaign numbers written on them if multiple campaigns are performed at the same time.

1.

When all specified repairs have been accomplished, prepare the campaign label (LRN0002LABEL) as follows:

a)

Place the label on a hard surface.

b)

Use a ballpoint pen to neatly write/scribe in the bare aluminum areas of the label the following information:

^

Service Campaign code "B134"

^

Your retailer code

^

The date of repair

2.

Clean all grease and dirt from the radiator support member.

3.

Peel the completed campaign label from the backing paper and position it on the cleaned area.

4.

Roll the label with the special roller tool to ensure proper adhesion.

All Other Service Bulletins for Navigation Module: > < Campaign - Navigation System Software Update|Page 7073