Range Rover (LM) V8-4398cc 4.4L (M62) (2003)
10. Remove 2 windscreen support blocks from body.
Refit
1. Carefully remove sealant from body to leave a smooth surface.
2. Original screen: Carefully cut back sealant to obtain a smooth surface without damage to obscuration band
3. Fit finisher to screen.
4. Fit support blocks to body.
5. Fit screen to body and centralize in aperture.
6. Use masking tape to establish reference marks as an alignment aid.
7. Remove windscreen and place on stand.
8. Clean sealant face on body and windscreen with solvent.
9. Apply etch primer to any bare metal on body.
10. Apply primer over etch primer.
11. Apply screen primer to sealant face on windscreen and allow to cure.
12. Apply activator over old sealant on body and allow to cure.
13. Fit pre-cut nozzle to sealer cartridge, remove lid, shake out crystals and fit cartridge to applicator gun. If necessary modify the nozzle to achieve
required bead section.