Range Rover (LM) V8-4398cc 4.4L (M62) (2003)
/v8-4398cc_4.4l_(m62)/Page-1853002.png)
-
When hub bearings are removed or displaced, new bearings must be fitted: do not attempt to refit the old hub bearings.
-
When fitting a bearing to a shaft, only apply force to the inner ring of the bearing. When fitting a bearing into a housing, only apply force to the
outer ring of the bearing.
-
In the case of grease lubricated bearings (e.g. hub bearings) fill the space between bearing and outer seal with the recommended grade of grease
before fitting seal.
-
Always mark components of separable bearings (e.g. taper roller bearings) when dismantling to ensure correct reassembly. Never fit new rollers in
a used outer ring; always fit a complete new bearing assembly.
Oil Seals
Oil Seals
General
Always renew oil seals which have been removed from their working location (whether as an individual component or as part of an assembly). NEVER
use a seal which has been improperly stored or handled, such as hung on a hook or nail.
-
Carefully examine seal before fitting to ensure that it is clean and undamaged.
-
Ensure the surface on which the new seal is to run is free of burrs or scratches. Renew the component if the original sealing surface cannot be
completely restored.
-
Protect the seal from any surface which it has to pass when being fitted. Use a protective sleeve or tape to cover the relevant surface.
-
Lubricate the sealing lips with a recommended lubricant before use to prevent damage during initial use. On dual lipped seals, smear the area
between the lips with grease.
-
If a seal spring is provided, ensure that it is fitted correctly. Place lip of seal towards fluid to be sealed and slide into position on shaft. Use fitting
sleeve where possible to protect sealing lip from damage by sharp corners, threads or splines. If a fitting sleeve is not available, use plastic tube or
tape to prevent damage to the sealing lip.
-
Grease outside diameter of seal, place square to housing recess and press into position using great care, and if possible a 'bell piece' to ensure that
seal is not tilted. In some cases it may be preferable to fit seal to housing before fitting to shaft. Never let weight of unsupported shaft rest in seal.
