Range Rover (LM) V8-4398cc 4.4L (M62) (2003)
/v8-4398cc_4.4l_(m62)/Page-1203003.png)
14.
Refer to GTR section 76.11.81 and install engine undertray.
15.
Ensure PAS reservoir fluid is at the correct level and install reservoir cap.
16.
Remove vehicle from lift and swivel plates.
CAUTION:
Do not hold the steering at full steering lock for longer than one second, as this may overheat the PAS fluid.
17.
Start engine and position the vehicle in a suitable location to perform the following static steering maneuver:
^
Quickly turn the steering to full right steering lock and 'bounce' steering on/off full lock five times.
^
Quickly turn the steering to full left steering lock and 'bounce' steering on/off full lock five times.
^
Complete five repetitions of the following steering cycle - full lock, to hold, to 90 degrees back.
^
Turn the steering to full right steering lock
^
Hold for one second
^
Quickly turn steering back 90 degrees.
^
Complete five repetitions of the following steering cycle - full lock, to hold, to 90 degrees back.
^
Turn the steering to full left steering lock
^
Hold for one second
^
Quickly turn steering back 90 degrees.
18.
Re-test vehicle for the squeaking noise.
19.
If the fault is still apparent, repeat the steering maneuver in step 17.
20.
Verify that the PAS reservoir fluid is at the correct level following bleed and test process.
