Range Rover (LM) V8-4398cc 4.4L (M62) (2003)
15.
Install the crown wheel assembly (Figure 33).
16.
Use a center punch to mark the differential with three dots in a triangular pattern in the position shown. (Figure 34)
CAUTION:
Ensure the mating faces are clean, before the sealant is applied.
17.
Apply sealant to the differential upper casing mating faces. (Figure 35)
CAUTION:
Ensure the bearing cup and shim is retained in the differential casing.
18.
Install the differential upper casing.
NOTE:
Tighten the bolts in the sequence shown.
19.
Following the sequence shown, install the 12 differential casing bolts and tighten to 45 Nm (33 lbf-ft). (Figure 36)
20.
Clean the RH driveshaft where the new clip is to be installed.
21.
Install a new clip to the right-hand driveshaft.