Range Rover (LM) V8-4398cc 4.4L (M62) (2003)
19.
Remove the right-hand tie rod and lower arm support.
CAUTION:
Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
20.
Position the right-hand lower suspension arm and align to the sub- frame; install a new bolt but do not tighten at this stage.
CAUTION:
Nuts and bolts must be tightened with the weight of the vehicle on the suspension.
21.
Position the right-hand tie rod and align to the sub-frame; install a new bolt but do not tighten at this stage.
CAUTION:
Use an open ended wrench on the flats provided to prevent the ball joint from rotating.
22.
Connect the right-hand front height sensor link and tighten the nut to 8 Nm (6 lbf-ft).
CAUTION:
Inspect PAS reservoir for presence of a 'Pentosin CHF202' label:
^
If label is present, indicating Technical Bulletin LTB00112 has been performed, use only Pentosin CHF202 PAS fluid (LRN003401).
^
If label is not present and Technical Bulletin LTB00112 has not been performed, use PAS Fluid - Texaco Cold Climate PSF 14315
(LRN2261).
NOTE:
It is not necessary to perform the front wheel alignment check.
23.
Refer to Workshop Manual (GTR) section 57 - STEERING (57.10.01) to install the steering gear. It is not necessary to perform the front wheel
alignment check.
24.
Lower the vehicle.
25.
Tighten the bolt securing the right-hand lower suspension arm to the sub-frame to 165 Nm (121 lbf-ft) plus a further 90-degrees.
26.
Tighten the bolt securing the right-hand tie rod to the sub-frame to 165 Nm (121 lbf-ft) plus a further 90-degrees.
27.
Fill the differential to the correct level with oil (LRN7591).