landrover Workshop Repair Guides

Land Rover Workshop Service and Repair Manuals

Body - Various Wind Noise Concerns|Page 4613 > < Body - Various Wind Noise Concerns
Page 2
background image

Repairs 10 - 13..........VARIOUS WIND NOISES No parts required.

WARRANTY CLAIMS:

Normal warranty policy and procedures apply. Material allowance is included in labor operation.

REPAIR PROCEDURE

REPAIR 1: ALL VEHICLES

A gap between the windshield trim and the roof causes a high-pitched hiss from the windshield at approximately 38 - 50mph (60-80km/h).

CAUTION:  

The top trim piece of the windshield must be protected to prevent damage. A gap must not be created between the bottom edge of the trim strip and
the windshield.

1. Using a nylon block and rubber mallet, move the windshield top trim upwards to close the gap. (Figure 1, Inset A)
2. Align trim to the roof until a "touch" condition is achieved along the entire length of the trim. (Figure 1, Inset B)

REPAIR 2: ALL VEHICLES

A gap or bulge between the windshield lower trim piece and the windshield causes a buzzing from the windshield area at highway speeds.

1. Lift wipers away from the windshield for access.
2. Clean the windshield at the junction with the plenum seal along the entire length of the plenum seal.

Body - Various Wind Noise Concerns|Page 4613 > < Body - Various Wind Noise Concerns