Range Rover (LM) V8-5.0L SC (2010)
/v8-5.0l_sc/Page-1466001.png)
Front Cross-Member: Service and Repair
Auxiliary Front Crossmember
Removal
1. Disconnect the battery ground cable. For additional information, refer to Specifications
2. Remove the LH and RH headlamp mounting brackets. For additional information, refer to Headlamp Mounting Bracket
3. Release the power steering hose from the auxiliary front crossmember.
-
Remove the nut.
-
Reposition the power steering hose.
4. Remove the auxiliary front crossmember.
-
Remove the 2 bolts.
5.
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the front axle cooling duct.
-
Remove the clip.
6. Remove the charge air cooler trim panel.
-
Remove the 5 clips.
7. Prepare the new panel for installation. For additional information, refer to Body
Installation
1. Install the charge air cooler trim panel.
-
Install the 5 clips.
2. Install the front axle cooling duct.
-
Install the clip.
3. Install the auxiliary front crossmember.
-
Install the 2 bolts.
4. Install the power steering hose to the auxiliary front crossmember.
-
Reposition the power steering hose.
-
Install the nut.
5. Install the LH and RH headlamp mounting brackets. For additional information, refer to Headlamp Mounting Bracket
6. Connect the battery ground cable. For additional information, refer to Specifications
