Range Rover (LM) V8-5.0L SC (2010)
drive out can only be claimed if the vehicle is brought back into the workshop for this action alone to be undertaken.
REPAIR PROCEDURE
RECONFIGURE RESTRAINTS CONTROL MODULE
CAUTION:
Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the vehicle.
CAUTION:
A Midtronics PSC-550 Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module programming.
1. Connect the Midtronics PSC-550 Vehicle Power Supply to the vehicle battery.
NOTE:
IDS must be loaded with IDS-DVD119_V8.06 or later and Calibration File 22 or later.
2. Connect the IDS to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.
3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.
4. From the Session Type screen, select the 'Campaigns' session type.
5. Follow the on-screen prompts until the 'Recommendations' tab is visible.
6. From the list of Recommendations, select the following:
^ Configure existing module > Restraints control module
7. Follow all on-screen instructions to complete this task.
8. Exit the current session.
9. Disconnect IDS and the Midtronics PSC-550 Vehicle Power Supply from the vehicle.